The ERS HV250is a 2-way in-wall speaker for use in a wide variety of applications, from stereo and whole-house music systems to complete home theaters. It may also be installed horizontally and is perfect for center channel applications. The ERS HV250 incorporates Infinity's patented Ceramic Metal Matrix Diaphragm (CMMDâ„¢) technology to eliminate unwanted resonances and deliver clear, undistorted sound. The ERS HV250 also incorporates a proprietary waveguide design to ensure smooth distribution of sound throughout the listening area. The white grilles and frames are paintable and allow the speakers to blend into any decor.

Frequency Response: 45Hz – 22kHz (±3dB); 38Hz (-10dB)
Recommended Amplifier Power Range: 10 - 125 watts
Sensitivity (2.83V @ 1m): 89dB
Nominal Impedance: 8 ohms
Crossover Frequency: 2,600Hz; 12dB/octave
Low-Frequency Driver: Dual 5" (130mm) CMMDâ„¢
High-Frequency Driver: 3/4" (19mm) CMMDâ„¢
Dimensions (H x W x D): 15-3/8" x 7-1/2" (391mm x 191mm)
Mounting Depth: 3-7/8" (98mm)
Cut-Out Diameter: 13-7/8" x 6-3/16" (356mm x 152mm)
Weight: 5.7 lb (2.6kg)

The type of enclosure housing the drivers. This describes the fundamental nature of how sound output and tuning are derived.

Not black and white

The nominal or normal impedance for the speaker at most frequencies

An additional magnet is provided internally which reduces the magnetic effects when in proximity to an old CRT-based display. This is a non-issue with flat panel displays or LCD/DLP rear projection sets.

Mid or mid-bass frequency driver size in inches

Mid or mid-bass driver type or material

Typically foam or rubber, the material that surrounds the cone. Rubber and similar materials will last longer and are more forgiving to environmental conditions.

Midrange driver size (typically given in inches)

The material which makes up the composition of the midrange driver

High frequency tweeter size in inches

Typically aluminum or silk dome, this describes the material used in the construction of the tweeter

Discrete connections for high and low drivers allowing them to be driven separately using two amplifier channels per speaker

The range of low to high frequency material that can be reproduced by this system

Maximum power (in watts) the system can either output or support

How loud the speaker would be at 1 meter if fed a 1kHz signal at 1 watt (2.83 volts)

There are currently no reviews for this product. Be the first to review by clicking below!

Review this product...